Glomex DANUBE R8500 Manuel D'installation Et Utilisation page 52

DANUBE R8500
Fig. 14
S
WARNING
Do not use power supply from secondary circuits.
This could jeopardize the operation of the equip-
ment.
NOTE: The polarity inversion on the power supply
blows the fuse to prevent any damage to the
antenna.
S
Pay attention not to bend the coaxial cables at a
right angle; the bending angle must always be
higher than 120°.
Fig. 15
NOTE: Do not cut the connectors of the coaxial
cables (the operation would not be guaranteed any
more) and always use the original GLOMEX cables
supplied, even with inappropriate dimensions (too
long). Do not use different cables, as it would
jeopardize the operation of the equipment.
4. Build in the control unit by using the GLOMEX
accessory (code 4.010.0008) by boring a hole
with a reciprocating saw and using the drill with
2.5 mm tip (use the cutting template in Fig. 16
for correct dimensions).
5. Connect the 1.5 m coaxial cable to the LNB IN
connector of
included).
NOTE: Maximum wall thickness for mounting the
control unit: 20 mm.
S
The antenna is designed to operate with one single
receiver; therefore, do not install signal splitters
upstream or downstream the control unit.
50
WARNING
the satellite receiver
WARNING
www.glomex.it
(not