Glomex DANUBE R8500 Manuel D'installation Et Utilisation page 51

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Operations to be carried out inside the boat.
1. Determine the correct position for the control
unit:
- it must be positioned near the satellite
receiver, as the provided coaxial cable is
1.5 m long;
- it must be reached by the power supply
cables coming from the control panel;
- it must be reached by the coaxial cable com-
ing from the antenna (10 m long);
- it must be positioned in a dry and ventilated
area.
2. Connect the coaxial cable of the antenna (pre-
viously installed) to the ANTENNA IN input on
the control unit and the 1.5 m coaxial cable to
the RECEIVER OUT output on the control unit.
Make sure that the cable cores are correctly
inserted in the central holes of the relevant
female connectors on the control unit (other-
wise, there would be a short circuit and the fuse
installed on the power supply line inside the
control unit would trip).
Manually screw in the ring nuts of connectors F.
Once the ring nuts have been manually
screwed in, tighten by ¼ turn by means of a
11 mm wrench.
S
WARNING
The inversion of the two cables jeopardizes the
operation of the equipment. Make sure you have
correctly installed the coaxial cables. In case of
damage, GLOMEX will not be directly liable for the
damage suffered by the receiver.
www.glomex.it
Red
Black
To the
receiver
Red
Black
Fig. 13
3. Connect the power supply cable of the control
unit to the connector of the power supply unit
V9119. Connect the power supply cable of unit
V9119 (12V) to a free switch for the on-board
electronic devices (min. 5A): connect the posi-
tive terminal to the red cable and the negative
terminal to the black cable. The power supply
line must have cables with a minimum cross
2
section of 2.5 mm
2
4 mm
for longer cables.
NOTE: The connection of power supply unit V9119
is necessary for a correct operation of the appli-
ance. Its presence guarantees a stabilization of the
voltage coming from the boat battery.
S
WARNING
Make sure you have installed power supply unit
V9119 between vehicle battery and control unit for
the correct operation of the appliance!
49
DANUBE R8500
From the
antenna
with a length up to 4 m, of

Publicité

Table des Matières
loading

Table des Matières