Glomex DANUBE R8500 Manuel D'installation Et Utilisation page 50

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

DANUBE R8500
7. Mount the coaxial cable onto the antenna:
- make sure that the cable core is correctly
inserted in the central hole of the female con-
nector on the antenna (otherwise, there would
be a short circuit and the fuse installed on the
power supply line inside the control unit would
trip, see page 63 for fuse replacement);
- manually screw in the ring nut of connector F;
- once the ring nut has been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench;
- insert the protection;
- make the coaxial cable pass through the previ-
ously bored 12 mm hole on the boat.
Fig. 10
Fig. 11
NOTE: For the connection of the antenna coax-
ial cable, it is not necessary to remove the
dome!
Central hole of
female connector
Central cable
conductor
48
8. Insulate with appropriate sealants the holes
drilled in order to prevent the passage of water.
Should it be necessary to shorten the cable,
please refer to the instructions given in Fig. 12.
Fig. 12
GL00095
www.glomex.it

Publicité

Table des Matières
loading

Table des Matières