Glomex DANUBE R8500 Manuel D'installation Et Utilisation page 67

4. No image on the TV (the led
on the control unit is green)
5. Intermittent images for short
periods
6. The equipment does not find
the satellite (the led on the
control unit is red)
www.glomex.it
- the receiver is off
- the TV set is off or has not
been tuned to AV
- wrong cable connection on the
receiver
- the channel list is not up-to-
date
- the selected satellite is not the
correct one
- the satellite signals
obstructed by trees, buildings,
overpasses, mountains
- the boat is at the boundary of
the coverage area
- bad weather conditions
- wrong SKEW adjustment
- temperature change
- it is necessary to calibrate the
sensors again
- the satellite signals
obstructed by trees, buildings,
overpasses, mountains
attachments installed on the
boat
- the boat is outside the signal
coverage area
- the boat is moving within the
first 60 seconds after turning
on the equipment
- bad weather conditions
- wrong SKEW adjustment
- inner failure
65
- turn off the control unit, turn on
the receiver and then turn on
the control unit again
- turn on the TV set and tune to
AV channel
- check that the SCART socket
between the TV set and the
receiver is installed correctly
- carry out the automatic chan-
nel search in the receiver
menu
- check the selected satellite
are - move the vehicle to allow an
unobstructed view
antenna
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
59 in this manual
- adjust the SKEW by following
the instructions on page 52
- turn off and on again the
antenna
- turn off and on again the
antenna
are - move the vehicle to allow an
unobstructed view
or antenna or correctly position
the antenna on the boat
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
59 in this manual
- turn off the equipment for 10
seconds, turn it on again and
make sure that the boat is still
or moves in a straight line dur-
ing the first 60 seconds after
being turned on
- adjust the SKEW by following
the instructions on page 52
- contact the Service Centre
DANUBE R8500
for the
for the