Assembly - Glomex DANUBE R8500 Manuel D'installation Et Utilisation

6.

ASSEMBLY

S
DANGER
While installing the antenna, wear the appropriate
safety equipment for the job to be carried out.
Operations to be carried out outside the boat.
1. First of all, make sure you have chosen a cor-
rect position to install the antenna (see section
5: "Installation").
2. Remove the antenna from the packaging box.
3. Carefully clean the 4 mounting plates (P) on the
antenna and the area in which the antenna will
be located with alcohol and let evaporate
before applying the sealant (Fig. 7).
4. Apply some sealant like SIKAFLEX®252 or
similar onto the plates (Fig. 8).
5. Place the antenna in the appropriate position
and apply a good pressure on the radome sides
to make the plates correctly adhere to the
mounting surface.
Wait for the silicone to solidify (time varies
according to outer temperature).
6. OPTIONAL OPERATION: drill the plates with
an 8 mm drill tip and fasten the antenna to the
boat with the appropriate through screws (Fig.
9).
P
P
Fig. 7
www.glomex.it
P
P
Fig. 8
Fig. 9
S
WARNING
Fastening with sealant is necessary and sufficient
for the correct use of the equipment.
Fastening with the screws (not included) is
optional.
Fastening with screws only does not guarantee
a perfect coupling of the radome to the boat.
GLOMEX declines any liability for an incorrect cou-
pling of the radome to the boat.
47
DANUBE R8500