Malfunctions; Servicing And Maintenance; Disposal And Recycling - GOLDSCHMIDT SMARTWELD SPARK Thermit Mode D'emploi

SMARTWELDSPARK
10

Malfunctions

The ERR LED goes on if an error occurs in the device or if the overheat control
is activated.
Troubleshooting if the overheat control activated:
1. Wait until the device has cooled down. This may take several minutes.
2. Then push the Start button.
If the ERR LED goes off after pushing the Start button, continue using
the device.
3. If not, let it continue to cool down for a few minutes, then push the Start
button again.
Troubleshooting in case of a device error:
If the ERR LED stays on even after allowing to cool multiple times, an error
occurred in the device. Do not try to correct the error yourself. Contact the
manufacturer's Customer Service instead (see Legal notice).
11

Servicing and Maintenance

Prior to using the device do a visual check for possible damages.
Only Elektro-Thermit GmbH & Co. KG or service centres authorized by Elektro-
Thermit GmbH & Co. KG may perform any necessary maintenance or repairs
to the device and its accessories. Performing maintenance or repairs yourself
is prohibited.
12

Disposal and Recycling

These general rules apply: All waste originating from welding work must be removed
from the track area and disposed of.
The table below lists the single components and the related waste management
possibility.
50
INSTRUCTION MANUAL