Igniting The Thermit Portion In The Crucible - GOLDSCHMIDT SMARTWELD SPARK Thermit Mode D'emploi

SMARTWELDSPARK
9.4.2 Igniting the Thermit
1. Remove the cover from the long life crucible and keep it in your hand or dip
electrodes 40 mm deep through electrode opening of the single use crucible
into the welding portion
2. Push the Start button.
The IGN LED flashes. The ignition voltage is now available and the device is ready
for ignition for a period of 30 seconds. Once the device correctly makes contact
with the Thermit
3. Dip the single use electrodes 40 mm deep into the Thermit
4. Immediately close the crucible with the cover and retreat at least six meters
from the device!
48
INSTRUCTION MANUAL
Portion in the Crucible
®
portion, an ignition is released after one second ignition delay.
®
Lightly stirring the igniter will increase the likelihood of ignition.
If no ignition takes place after pushing the Start button
(within 30 seconds e.g. due to improper contact with the
Thermit portion), the process is automatically cancelled.
®
The Thermit portion is ignited when the device gives an
®
acoustic signal and the IGN LED glows constantly. The
operator has two seconds to close the crucible with the
cover or remove the device from the crucible and retreat
to the safe distance.
The reaction of the Thermit
burn hazard!
Hot single use electrodes pose a burn hazard!
Bursts of flame pose a serious burn hazard!
portion poses a serious
®
® portion.