Correctly Charging The Batteries; Preparing The Device For Use - GOLDSCHMIDT SMARTWELD SPARK Thermit Mode D'emploi

SMARTWELDSPARK
9.2

Correctly Charging the Batteries

Make sure that the batteries are fully charged prior to the initial use.
The battery recharger has a display showing the charge condition of the inserted
battery (see Fig. 7).
9.3

Preparing the Device for Use

Proceed as follows:
1. Insert single use electrodes into the front of the electrode guide, until a clear
snap resistance is noticeable.
2. Insert a battery with sufficient charge into the device.
46
INSTRUCTION MANUAL
Overheating or damage to the battery: The left display of the
battery recharger (Fig. 7) indicates if the battery is overheated
or damaged. If the display comes on red, immediately remove
the battery from the battery recharger to avoid any further
damage or chemical leakage. Do not use a defective battery.
Dispose of the battery according to all applicable rules and
regulations (see chapter 12).
Make sure that the battery is only charged as long as necessary.
This prevents damage and reduction to the charge capacity.
The charge condition of the battery shows on the display
(under BAT LED) after the device is switched on (see related
table in chapter 8.3).
Fig. 7: Display of the
battery recharger