Bissell CROSSWAVE 1785 Série Mode D'emploi page 8

Cleaning Area Rugs
NOTE: Before cleaning area rugs, test an inconspicuous area of the rug for
colorfastness. Also, please check manufacturer's tag before cleaning area rugs for
any specialized cleaning instructions. Not for use on silk or delicate area rugs.
1
Plug machine into a
properly grounded
outlet.
4
Before each use, hold the solution spray
trigger for 10 seconds to prime the
system with cleaning solution. LED lights
illuminate when holding the trigger.
NOTE: When solution is flowing, you will
see bubbles forming at the edges of the
brush roll window.
NOTE: The RUG button dispenses twice the solution of the HARD FLOOR button
to help with area rug cleaning.
TIP: For the most thorough clean, make 4 wet passes and 4 dry passes using
overlapping strokes over each area you clean on your rugs.
ATTENTION
Do not over wet carpet. Be careful not to run over loose objects or edges of area rugs.
Stalling the brush may result in premature belt failure.
8
www.BISSELL.com
2
Select cleaning mode:
To start cleaning your rugs, turn
the machine ON pressing the
RUG button. Once the setting is
selected, the dry vacuum will turn
on. To turn OFF, press the RUG
setting a second time.
5
To clean, hold the solution
spray trigger to apply
solution on both forward
and backward passes.
3
Recline the body of the
machine backward to start
the brush roll spinning.
To stop the brush roll
spinning, you will need to
stand the machine upright.
6
To dry area rugs faster,
release the trigger and
clean a second pass
without dispensing
solution.