Cleaning Your Hard Floors
1
Plug machine into a
properly grounded
outlet.
4
Before each use, hold the solution
spray trigger for 10 seconds to prime
the system with cleaning solution.
LED lights illuminate when holding the
trigger.
NOTE: When solution is flowing, you
will see bubbles forming at the edges
of the brush roll window.
TIP: When cleaning excessively dirty or muddy hard floors or if your brush
roll looks dirty, use the Easy Clean Storage Tray to rinse your brush roll before
cleaning your area rugs.
TIP: For overly challenging and stuck-on messes on your hard floors, activate
the RUG mode and hold your CrossWave® over the mess. Using short passes
while holding the trigger allows the multi-surface brush to go to work.
2
Select cleaning mode:
To start cleaning your hard floors,
turn the machine ON pressing the
HARD FLOOR button. Once the
setting is selected, the dry vacuum
will turn on. To turn OFF, press the
HARD FLOOR setting a second
time.
5
To clean, hold the solution
spray trigger to apply
solution on both forward and
backward passes.
3
Recline the body of the
machine backward to start
the brush roll spinning.
To stop the brush roll
spinning, you will need to
stand the machine upright.
6
To dry hard floors faster,
release the trigger and
clean a second pass
without dispensing
solution.
www.BISSELL.com
7