Storch Airless SL 1200 S Mode D'emploi page 147

INSTRUCTIONS:
The device cannot be operated if cables are missing or kinked. On re-assembly, make sure that all cables are connected
and that they are not kinked.
Sensor
1. Remove the four screws, the heat sink and lower the pressure regulator unit.
2. Separate the sensor cable from the controller card.
3. Unscrew the sensor by holding it with a 19 mm (3/4 inch) spanner.
4. Re-assemble in reverse order. Seal the thread of the sensor with Teflon tape.
INSTRUCTIONS:
The device cannot be operated if cables are missing or kinked. On re-assembly, make sure that all cables are connected
and that they are not kinked.
Potentiometer
1. Lower the pressure regulator unit as described above.
2. Separate the potentiometer cable from the pressure regulator unit.
3. Release the adjusting screw in the potentiometer head using 1.6 mm (1/16 hexagon socket wrench) and remove the
head and the spacer.
4. Using a 12.7 mm (1/2 inch) spanner or a socket wrench, remove the nut from the potentiometer shaft.
5. Pull the whole potentiometer assembly out of the connecting box.
6. Re-assemble in reverse order.
INSTRUCTIONS:
The device cannot be operated if cables are missing or kinked. On re-assembly, make sure that all cables are connected
and that they are not kinked.
ON/OFF switch
1. Lower the pressure regulator unit as described above.
2. Separate the two cables on the ON/OFF switch.
3. Release the nut on the switching axis using a 9/16 inch spanner.
4. Re-assemble in reverse order.
INSTRUCTIONS:
The device cannot be operated if cables are missing or kinked. On re-assembly, make sure that all cables are connected
and that they are not kinked.
LCD display
1. Lower the pressure regulator unit as described above.
2. Release the two nuts in the LCD display assembly and remove the assembly.
3. Re-assemble in reverse order. Tighten the two nuts so they are hand tight. Do not over-tighten the nuts, as this
could damage the display.
INSTRUCTIONS:
The device cannot be operated if cables are missing or kinked. On re-assembly, make sure that all cables are connected
and that they are not kinked.
147 Original instruction