Stroller Features; Age Guidelines; Stroller Assembly; Unpacking The Stroller - BOB IRONMAN DUALLIE Guide De L'utilisateur

BOB Gear by Britax

Stroller Features

Canopy
Seat Harness
Seat Storage
Pocket
Fender
Brake Caliper
Assembly
Wrist Strap
Seat Back
Pocket
Seat Retention Strap
Parking Brake
Rear Wheel
Removal Lever
Actual product may vary from images
4

Age Guidelines

Hand Brake Lever Prior to first use, consult with your
pediatrician regarding suitability of
stroller use with your child.
Adjustable
Please note that infants incapable
Handlebar
of holding their head up must have
Handlebar
additional head and neck support to
Release Lever
ride safely and comfortably. From 0-8
weeks, or as recommended by your
pediatrician, the use of an infant car
seat and adapter is encouraged.
Children are unique and develop at
different rates. Most may not have the
neck strength for jogging or off-road
motion until 8 months of age. For
Shock Release
jogging or off-road stroller use, BOB
Knob
Gear by Britax recommends you limit
Swing Arm
use of this stroller to children over the
age of 8 months.
Please refer to the below table for
age/use guidelines:
Low Boy
Cargo Basket
IRONMAN DUALLIE/S.U.S. DUALLIE User Guide
RECOMMENDED STROLLER USE
0 - 8 Weeks Walk Only with
Infant Car Seat &
Adapter *
8 Weeks - 8 Months Walk Only
8 Months - 5 Years Jogging/Off-Road
* See BOB Infant Car Seat Adapter User
Guide for maximum occupant weight.

Stroller Assembly

Unpacking the Stroller

Remove all packaging materials
and discard to avoid choking
and suffocation hazards�

Fender Installation

Before installing the front wheel, you
will need to attach the fender.
1� Remove Mounting Screws
Two fender mounting screws can
be found already installed in the
stroller frame. Remove the two
fender mounting screws with a
Phillips head screwdriver.
Front
Fender
Mounting Holes
NOTE: You might want to remove
a fabric screw (right or left) to give
better access to the cross tube
mounting hole.
2� Align Fender and Cross Tube Hole
Align the hole in the tab of the
fender with the threaded hole in
the center of the front cross tube
and install screw.
3� Align Fender and Brake
Mounting Hole
Align the hole in the fender with
the hole in the brake mounting
plate and install screw.
4� Tighten Screws
Center fender on stroller and
tighten screws. Reinstall and
tighten any additional fabric
screws that had been removed.
5