TOPRO TAURUS E Basic Manuel D'instructions page 17

Masquer les pouces Voir aussi pour TAURUS E Basic:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
EN
You can extend the lifetime of the battery by occasionally recharging it even though it is not fully discharged. If the
battery level drops below the critical level and the system shuts down, you must wait at least one minute before in-
serting a different battery and using the system again. If the walker is not to be used for an extended period (several
days or weeks), the battery should be removed from the controller to avoid deep discharge, which can cause lasting
damage to it. Avoid getting metal shavings or other magnetic objects on the battery poles or in the charger.
Charge cycle and LED indications
LED 1: YELLOW
LED 2: NO LIGHT
LED 2: BLUE
LED 2: GREEN
LED 2: BLUE LIGHT FLASHING
Be aware:
If a fault occurs, the Blue LED will flash. This is then an indication that the battery is faulty and needs to
be removed. The C3 charger will then not commit charging.
When the battery level is very low, it might only be possible to adjust the height of the walker down, not
up. The battery has to be reset if this occurs. Take the battery out of the control box and press the red
height adjustment button on the handle (see illustration 4) until you hear a beep.
Different beep signals:
Short "beep...beep" from the control box every 24th second = low battery level. Charge the battery.
Long "beeeeep" when the battery is put in the control box = good connection
Short "beep...beep when the walker is being raised and lowered = low voltage. The battery should be repla-
ced. If recharged, the battery will still give power but only for a limited time.
Long "beeeeep" when the Taurus is being raised and lowered = battery voltage lower than 17.6 V. It will only be
possible to lower it, not raise it.
Short "beep...beep...beep...beep" means too high temperature inside the control box. Stop using until the
control box has cooled down.
Transport
The walker can be transported either in vertical or horizontal position. The walker should be set in the lowest height
position, to save space and ease the handling. Ensure that the foot brakes are on. Be careful when loading the walker
into a vehicle, giving attention to securing of the item.
Storage
The walker should be stored indoors and in an upright position.
The maximum storage temperature is 50 °C. The walker must cool down for one hour at 25 °C before use.
The minimum storage temperature is −20 °C. The walker must warm up three hours at 25 °C before use.
Material // Recycling
The walker is made of plastic-coated aluminium pipe, plastic couplings and material of plastic and polyester. The
forearm cushions are of polyurethane. Most parts can be recycled. Dispose the walker according to the applicable
regulations in your country. For information, please contact your public authorities.
The battery contains NiMH (nickel). Do not dispose the battery in ordinary household waste, some communities
offer recycling or collection of batteries.
Allergic Reactions
No known allergic reactions.
104801 – V2, 2021-04
LED
www.topromobility.com
TAURUS E
MODE
Charger connected to power
No battery in charger
Battery in charger, charging
Charging complete
Faulty battery, not charging. Remove battery.
EN
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Taurus e premium

Table des Matières