Safety Instructions - Storch ProDist compact Mode D'emploi

Safety instructions

The device uses a voltage range that can pose a hazard for humans
and animals. The device must only be opened and/or disassembled by
authorised persons. Similarly, maintenance and repairs must be perfor-
med by a qualified electrician or an authorised repair shop. The owner/
operator operates the device on their own liability and at their risk.
Before using the device, read and make sure you understand all the
instructions in this manual. Failure to observe instructions can cause a
risk of laser radiation hazard, electric shock and/or physical injury.
CAUTION: Never attempt to modify the function of the device
in any way. This can lead to hazardous laser radiation.
LASER BEAM. Never look into the beam. Laser class 2
device. Only switch on the laser beam when you are using the
device. The laser switches off automatically after 30 seconds.
To switch off the laser manually, tap the
Improper execution of operational procedures or the use of
operating and adjusting elements in a way other than that
specified in this manual can result in hazardous exposure to
radiation.
The use of optical instruments such as telescopes to view the
laser beam aggravates its potential for eye damage.
The device is equipped with an integrated laser. This is a class 2 laser
with a maximum output of 1 mW and a wavelength of 635 nm. This
type of laser will not normally cause any eye damage. But you should
still not look directly into the beam as this can cause flash blindness.
The laser distance measuring device has the following label
60
button.