Safety Precautions, Utilisation And Disclaimer; Device Description - Storch HPM 3000 Mode D'emploi

Safety precautions,
utilisation and
disclaimer
This measuring instrument fulfills
the applicable standards of Euro-
pean and national guidelines and has
been constructed in accordance with
state of the art technology. Pay close
attention to the instructions and infor-
mation contained in the instruction
manual in order to ensure safe utilisa-
tion.
Devices exhibiting
defects or damage should not be
used.
Before conducting each measurement
make sure that there are no electri-
cal wires or other supply lines in the
measuring area.
Do not measure by, in or on metallic
surfaces and objects.
The protective cap must be attached
before and after conducting the mea-
surements. If the device is handled
improperly when measuring, there is
a risk of injury from the open measu-
ring points.
The determined measurement results
and all conclusions are exclusively
the responsibility of the user. No lia-
bility is assumed in any case for any
damage which may arise from the use
of the equipment or the determined
results.
If there are any doubts with regard to
theoperating reliability of the instru-
ment, then it should be returned to
the manufacturer for examination.
Description of the moisture
measuring device HPM 3000
The electronic moisture measuring
device HPM 3000 serves for deter-
mining the moisture (proportion) in
wood, plaster, brickwork and other
building materials.
A quick and accurate measurement
with corresponding characteristics can
be conducted on the basis of the con-
any technical
ductivity/resistance measurement.
The LED display and the accompa-
nying table for reading the moisture
level make it easy to use the instru-
ment and this also ensures a quick
evaluation of the tendency of moi-
sture.
Measurements on surfaces or at
depths close to the surface are con-
ducted with the integrated measuring
needles. After actuating the release
mechanism you can extract the mea-
suring needle head from the housing
and even measure difficult to access
areas with the help of the 40 cm
(approximately) coiled cord. When
reinserting the needle head please
make sure that it engages correctly
and that the coiled cord retracts into
its designated opening. A pluggable
depth measuring sensor for conduc-
ting measurements in plaster and
brickwork and a hammer electrode
are both available as optional acces-
sories.
35