INTRODUCTION
The TouchPad
The system automatically enables the built- in TouchPad. So, if you´re using any
version of Windows , you don´t have to install any other drivers for it.
Á
Figure 13
Konfiguration des TouchPad und der Knöpfe
You can configure the functions from the TouchPad driver icon on the
Task Bar.
You may toggle the TouchPad on and off by means of the Fn and F12 keys
as indicated in "Key Combination"
You can also add a mouse to your notebook computer. You can use a mouse
through either the PS/2 interface or through one of the USB ports.
ATTENTION
56
À
Â
Ã
Please note that peripherals (printers, digital
cameras, etc.) which attach to your
computer by either USB or IEEE1394 ports
may be connected after Windows is up
and running. All other peripherals must be
connected before you turn on the system.
(1)
sensor pad
(2)
left „mouse „button
(3)
Rocker Switch - may be configured
to function as a "third" button if
you prefer
(4)
right „mouse" button
Note for left-handers:
Most operating systems allow you to
reverse the mouse-button settings
ATTENTION