Connecting The Power To The Unit; Connection Process - Gewiss JOINON Manuel D'installation Et Usage

Gewiss
In the event that it is not installed at the bottom of the unit, the support must be secured to the wall as
shown in the following image.
3. Check that the unit properly secured.

7.2.2. Connecting the power to the unit

Cabling requirements
The connection must meet certain requirements:

Connection process

In order to connect the unit it is not necessary to open its front enclosure. A window is located at the bottom of the
unit, to access the terminal block to which to make the connection.
Upon receiving the unit the cover of this window is not installed.
18
Connection specifications
Connection type
Number of conductors
Nominal current
Conductor maximum diameter
Single phase
2P + E
up to 20 A
10 mm (2 x 6 mm
2
ABA2023IQM01_ - 7.55.4.412.2 - Installation and Operation Manual
ABA2023IQM01_ - 7.55.4.494.0
Installing and connecting the unit
)
2