Safety Instructions - Storch VacTec 25 Mode D'emploi

Safety instructions

Danger of suffocation: Keep packa-
ging material such as plastic bags
away from children.
Never stand or sit upon the vacuum
device.
Particular caution is advised when
ascending stairs. Pay attention to
standing safely.
Do not pull the suction hose and con-
nection line over sharp edges, kink it
or shut it.
Always lay the suction hose and con-
nection line so that nobody may trip
over them.
In case of any leakage of foam or
liquid, immediately switch off the
vacuum device.
Always keep dry the inside of the lid.
Do not start the vacuum device inclu-
ding its accessories if:
the vacuum device shows detectable
damage (fissures/cracks);
the power connection line is defec-
tive or shows fissuring or ageing; or
any invisible defect is suspected
(after a fall).
Do not allow the rotating brushes to
get into contact with the power con-
nection line.
DANGER
Do not operate the vacuum device
where there is danger of explosions.
Keep away the vacuum device from
inflammable gases and substances.
DANGER
Do not aspirate any combustible or
explosive solvents, materials soaked
in solvents, explosive dusts, liquids
such as petrol, oil, alcohol, diluents or
materials hotter then 60 °C (140 °F).
Otherwise there will be danger of fire
and explosions!
DANGER
Have repairs been made only by
experts, e. g. the producer's service.
Use original spare parts only.
Improperly repaired devices pose a
hazard for the user.
DANGER
Use the socket of the vacuum device
only for the purposes defined in the
instruction manual.
In case of any inappropriate usage,
improper operation or repair, the pro-
ducer shall be exempt from liability.
Do not use any damaged extension
lines.
If the connector line of the vacuum
device has been damaged, it must be
replaced with a special connector line
which is available from the producer
or their service.
Electric brushes: Do not allow the
rotating brushes to get into contact
with the power connection line.
The voltage on the type sign must
correspond to the grid voltage.
85 Translation of the original instruction