Commissioning; Switching On And Off - Storch VacTec 25 Mode D'emploi

2. Commissioning

2.1 Switching on and off

The plug socket on the vacuum cle-
aner will always be live when the
mains plug is plugged in, irrespec-
tively of the position of the switch.
Electric tools and compres-
sed air tools must be swit-
ched off when they are
connected
NOTE
If the switch is in the >0< position,
the plug socket on the vacuum clea-
ner can be use as an extension lead.
Connection value: Vacuum cleaner +
connected unit, maximum 16 A.
Insert the plug into socket
> 0 < Vacuum cleaner is switched
off
> I < Vacuum cleaner switched
on without shaker function
>A< Vacuum cleaner on standby
The vacuum cleaner only
switches on when the tool
is switched on.
After the tool is switched off, the
vacuum cleaner runs on for approx.
10 sec to prevent any residue from
collecting in the hose.
>R< Filter cleaning function
>RA< Ready mode like >A< plus
automatic filter cleaning.
Set the vacuum cleaner to the switch
position >0<.
Pull out the plug after you have finis-
hed.
Fix the suction hose in the accessory
storage location* on the back of the
container for storage.
The ends of the hose can be pushed
into each other to prevent particles of
dirt from coming out.
CAUTION
Selector switch for minimum material
flow (horn and light) on vacuum clea-
ners classes „M" and „H".
In the modes >A< and >RA< the follo-
wing setting is made, depending on
the diameter of the hose:
Inside diameter
of tht hose
ø 35 mm
ø 27 mm
ø 21 mm
Push the plug of the vacuum cleaner
into the plug socket.
Set the desired operating mode on
the switch.
The vacuum cleaner is ready for suc-
tion.
After vacuum cleaning, set the switch
to >0<.
The vacuum cleaner is switched off.
Pull the mains plug of the vacuum
cleaner out of the plug socket.
Secure the mains cable.
Remove the electric/compressed air
tool.
* depending on the equipment vari-
ant
89 Translation of the original instruction
Switch
position
70 m /h
3
40 m /h
3
20 m /h
3