Accessories - Storch HPM touch pro Mode D'emploi

Accessories

Contact Check
Item no. 60 82 46
For determining the application readiness of screed, con-
crete, plaster and mortar down to a depth of 5 cm
Enhances the measuring device by the CM% value display
1. Connect the Contact Check to the measuring device using
the mini USB. The sensor is identified automatically and
also automatically starts measurement mode.
2. If required, select a matching characteristic.
3. Position the measurement ball on the surface you would
like to measure at an angle of 90 degrees. Do not apply
additional pressure or excessive force.
4. After the measurement the measurement result remains
visible on the display until the next measurement.
5. If required, save the determined measurement result in the
device archive.
144