Accessories - Storch HPM basic Mode D'emploi

Accessories

Measurements using HPM clima taking into account the
ambient temperature - item no. 60 83 03
1. Measure the ambient temperature using the HPM clima
climate measuring device.
2. Enter the measured ambient temperature in °C via the
HPM basic moisture measuring device menu.
3. Measure the material moisture using the HPM basic and
obtain even more precise measurement results by taking
into account the ambient temperature.
Connection and operation of the depth measuring sensor for
conducting measurements inside plaster and brickwork - item
no. 60 80 10
1. Drill two 6 mm diameter holes into the material to be exa-
mined (max. up to 23 cm).
2. The distance between the holes should be 50 mm +/- 20
mm, because a deviation of this range of tolerance can fal-
sify the measured value.
3. Select an appropriate drilling depth in order to obtain a cle-
ar representation of the situation of the source of moisture.
4. Place the measuring needle adapter on the measuring
needles of the HPM basic and measure the desired area
with the depth measuring sensor.
After drilling wait around 30 minutes for the degree of moi-
sture that has evaporated as a result of the drilling heat
to reach its original value again. Otherwise the measured
value results can be falsified.
In certain circumstances this may even take up to 24 hours
and as a result the measurement will only be possible on
the following day. For example for measurements in con-
crete.
58