Technical Data; Accessories, Scope Of Supply - Storch HPM 3000 Mode D'emploi

Technical data

Display
Power supply
Housing
Storage temperature
Application temperature
Relative humidity
Wood moisture
Material and building material
Accuracy
EMV: Complies with the regulations determined in EU Directive 2004/108/
EC concerning electromagnetic compatibility.
EN50081-1(2); EN50082-1(2), EN61326-1-2
Accessories
7.1 Connection and operation of the
depth measuring sensor for conduc-
ting measurements inside plaster and
brickwork
Item No. 60 80 10
When conducting
deep in material youn will need to use
the pluggable depth measuring sen-
sor.
1.Drill two 6 mm diameter holes into
the material to be examined (max. up
to 23 cm).
2. The distance between the holes
should be 50 mm + - 20 mm, becau-
se a deviation of this range of toleran-
ce can falsify the measured value.
31 LEDs
Mignon LR6 battery (2 pce.),
Battery change display
Plastic ABS
170 x 75/50 x 30/25 mm
-25 to 50° C
-10 to 50° C
0 to 90 % non condensing
6 - 30 weight %
0 - 100 digits
+/- 1 %
3. Select an appropriate drilling depth
in order to obtain a clear representa-
tion of the situation of the source of
moisture.
4.
measurements
adapter onto the measuring needles
on the HPM 3000+ and measure the
desired area with the depth measu-
ring sensor.
After drilling wait around 30 minutes
in order for the degree of moisture
that has evaporated as a result of the
drilling heat to reach its original value
38
Place the measuring needle