Superrollo GW60 Manuel D'installation Et D'utilisation page 96

i
22. What to do if... ?
Fault
... the roller shutters stop while
lowering?
... the roller shutters suddenly stop
while lifting?
... the belt winder will not move
up or down?
96
Cause / solution
a) The roller shutters may have hit an
obstacle.
Move the roller shutters back up and
remove the obstacle.
b) The roller shutters may be too light.
Load the roller shutters by e. g. inser-
ting a section of flat steel into the
lower-most slats.
a) The drive is blocked, e. g. due to
freezing of the roller shutters or other
obstacles.
b) Possibly the roller shutters are not
running sufficiently smoothly. Check
the roller shutters and roller shutter
guides.
c) The roller shutters may be too heavy.
The maximum lifting power of the belt
winder may have been exceeed, see
page 97.
The max. drive running time has been ex-
ceeded, see page 83 and page 97. The drive
is too hot.
The belt winder will be operational again
after 30 minutes.
EN