Removing The Flush-Mounted Belt Winder (E.g. In The Event Of A Move) - Superrollo GW60 Manuel D'installation Et D'utilisation

i
18. Removing the flush-mounted belt winder (e.g. in the event of a move)
1.
Delete all settings.
2.
Fully close the roller shutters.
Press and hold the button.
3.
In doing so, pull the belt as far as
possible upwards out of the belt
winder.
Risk of injury due to the winding
wheel.
Never touch the winding wheel
compartment when the drive is in
operation. Remove the mains plug
before touching the winding wheel
compartment.
4.
Remove the power supply from
the socket, open the operating
panel and release the belt from
the fixing hook.
Pull it out completely and subse-
quently dismantle the belt winder.
5.
Finally release both connectors
from the back of the device with a
small screwdriver and dismantle
the solar sensor.
+ +
EN
91