Automated Solar Function: Setting Limit Values - Superrollo GW60 Manuel D'installation Et D'utilisation

i
16.2. Automated solar function: Setting limit values
The automated solar function is switched on by setting or changing the limit
values.
Accept current brightness as limit value and switch
on the automated solar function.
1.
Press the buttons simultaneously.
2.
The current brightness level is now
the limit value.
If this value is exceeded, the roller
shutters will move down to the
solar sensor.
NOTE
If the current brightness value lies
outside of the measuring range
during setting of the limit value,
then the solar limit value flashes
briefly and the limit value is set to
the measuring range limit.
+
Solar indicator light
EN
89