Superrollo GW60 Manuel D'installation Et D'utilisation page 66

i
9. Flush-mounted installation
7.
Connect the power supply and the
solar sensor.
Now connect the power supply and
the solar sensor to the rear side of
the belt winder, if required.
CAUTION
Incorrect connection of the plug
may result in destruction of the
belt winder.
◆ Plug both plugs true to side
into the opening. Observe the
connection symbols on the
type plate.
◆ Never insert the plugs onto the
PCB with force.
8.
Lay the connection cables in a safe
manner.
Lay the connection cables on the
rear side of the device as shown in
the figure and feed the two cables
through the notches and into the
mounting frame.
66
Solar sensor
Power supply
Feed the
cables through
the notches.
EN