Manual Operation - Superrollo GW60 Manuel D'installation Et D'utilisation

i
12. Adjusting the end points
Changing and correcting the end points
5.
Move the roller shutters to the
centre position and re-adjust the
respective end point.
NOTE
You may have to readjust the end
points after a period of time as the
belt may elongate during operation.
i
13. Manual operation
Manual operation is possible in
any mode and has priority over the
programmed automatic functions.
NOTE
◆ The end point settings are main-
tained during manual opera-
tion.
◆ You can operate the belt winder
max. 5 minutes at maximum
load. Afterwards, allow the
drive to cool for approx. 30
minutes.
or
EN
Operating
buttons
83