Publicité
Les langues disponibles
Les langues disponibles
i
9. Flush-mounted installation
5.
Use existing installation holes.
You require two installation holes
in order to fasten the belt winder.
Normally you can use the existing
installation holes in order to screw
the belt winder in place.
If this is not the case, slide the belt
winder into the belt box and mark
the required installation holes, oth-
erwise proceed with step 7.
NOTE
Observe the hole spacing for the
flush-mounted device.
6.
Drill installation holes
(if necessary).
Subsequently pull the belt winder
back out of the belt box and drill
the installation holes with a suitable
6 mm masonry drill. Afterwards,
insert the included installation rawl
plugs into the holes.
55
EN
65
Publicité
Chapitres
