Connecting To A Computer; Connecting To A Serial Printer - Uline Ohaus Defender 5000 Mode D'emploi

SERIAL COMMUNICATION AND PRINTER SETUP CONTINUED
RS-232 INTERFACE
RS-232 (DB9) Pin Connections:
Pin 2: Scale transmit line (TxD)
Pin 3: Scale receive line (RxD)
Pin 5: Ground signal (GND)
Pin 7: Clear to send (hardware handshake) (CTS)
Pin 8: Request to send (hardware handshake) (RTS)
Use the built-in RS-232 port to connect to either a computer or a printer.

CONNECTING TO A COMPUTER

1. Connect to the computer with a standard (straight-through) serial cable.
2. Use HyperTerminal or a similar terminal software to test communication with the computer.
3. Set up HyperTerminal as follows:
a. Choose New Connection, "connect using" COM1 (or available COM port).
b. Select Baud=9,600; Parity=8 None; Stop=1; Handshaking=None. Click OK.
c. Choose Properties/Settings, then ASCII Setup. Check boxes as illustrated:
(Send line ends...; Echo typed characters...; Wrap lines...)
4. Verify communication by pressing the print button.
NOTE: If HyperTerminal is set up properly, the value on the display will be shown in the window.

CONNECTING TO A SERIAL PRINTER

Connect the cable supplied with the printer to the scale's RS-232 port. Make sure that the balance and printer
communication settings match.
Test communication with the printer by pressing the print button. If the balance and printer are set up properly, the
value on the display will print.
PRINTOUTS
Printout string for g, kg, lb, oz units:
CHECK WEIGHING APPLICATION
WEIGHT
FIELD
(RIGHT ALIGNED)
Length 11
NON-CHECK WEIGHING APPLICATION
WEIGHT
FIELD
(RIGHT ALIGNED)
Length 11
Each field is followed by a single delimiting space (ASCII: 32).
PAGE 29 OF 101
UNIT
SPACE SPACE
(RIGHT ALIGNED)
1 5
UNIT
SPACE SPACE
(RIGHT ALIGNED)
1 5
5
STABILITY
SPACE
(?) (RIGHT ALIGNED)
1 1 1
STABILITY
SPACE
(?) (RIGHT ALIGNED)
1 1 1
RxD
GND
9
RTS
T/N/G/PT APPLICATION STATUS
SPACE
(RIGHT ALIGNED)
2 1
T/N/G/PT
TERM.
2 2
TxD
1
6
CTS
TERM.
6 2
0621 IH-8105