Transaction Counter - Uline Ohaus Defender 5000 Mode D'emploi

When Dual interval is selected, the terminal functions
with two intervals, each with its own capacity and
graduation. In addition to these parameters, the
following two parameters are available:
>|2|< Capacity
>|2|< Graduation
CAPACITY
Set the scale capacity from 1 to 999999.
>|1|< Capacity
Specify the weight capacity for interval 1. If Single
interval is enabled, this will be the scale capacity. If
Dual interval is enabled, this will be the first range.
>|2|< Capacity
Specify the weight capacity for interval 2. If Dual
interval is enabled, this will be the scale capacity, and it
must be bigger than >|1|< Capacity. If Single interval is
enabled, this parameter will not be shown.
GRADUATION
Set the scale readability from 0.0001 to 100.
>|1|< Graduation
Specify the graduation for weighing interval 1. If Single
interval is enabled, this will be the graduation for the
entire weighing range of the scale. If Dual interval is
enabled, this will be the graduation used in the lower
interval.
>|2|< Graduation
Specify the graduation for interval 2. If Dual interval
is enabled, this will be the graduation for the second
weighing range of the scale. If Single interval is enabled,
this parameter will not be shown.
NOTE: Graduation settings are limited to values
from Capacity divided by 600 to Capacity
divided by 75,000. Therefore, not all settings
are available for each capacity.
LANGUAGE
Set the language displayed for menus and displayed
messages.
English
Deutsch
Français
PAGE 8 OF 101
OPERATION CONTINUED
Italiano
Polski
Spanish
POWER ON ZERO
Zero the balance at Power On.
Off = disabled
On = enabled
POWER ON UNIT
Set the unit that will be displayed at Power On.
Automatic
g
kg
lb
oz
lb:oz
t (Metric Tonne)
ton (Short Ton)
KEY BEEP
Set how the beeper sounds when a key is pressed.
Off = no sound
On = sound

TRANSACTION COUNTER

The transaction counter is a seven-digit counter that
tracks the total transactions. When the value reaches
9,999,999, the next transaction causes a roll-over to
0000001.
Off = The transaction counter will not increase.
On = The transaction counter will increase with
the additional menu item Next Transaction
available.
NOTE: If the transaction counter is set to On,
the count number increases when the
key is pressed.
Next Transaction
The value of the next transaction displays in the Next
Transaction field.
Reset
Reset the Setup menu to the factory defaults (except
Range, Capacity and Graduation).
No = not reset.
Yes = reset.
Print
Units
0621 IH-8105