Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ATTACHING INDICATOR TO THE COLUMN
1.
Place the indicator bracket onto the top (flat side)
of the support bracket. Align the large center holes
and four small holes.
2. Insert four small Phillips head bolts through the small
holes on top of the indicator bracket and the support
bracket. Tighten until pieces are securely attached.
3. Feed black display cable from the display indicator
through the large center holes in the indicator bracket
and support bracket. Connect to the display cable
end at the top of the column by aligning holes and
pushing connectors together. Twist a quarter of a
turn to lock into place. (See Figure 7)
Figure 7
4. Place support bracket into the column with the
display facing the platform. Pull display cable all
the way through the column so excess is under the
base bracket. Make sure RS-232 cable is on the
back of the display. (See Figure 8)
Display
Knob
Indicator
Bracket
RS-232
Cable
Column
Figure 8
5. Tilt display to desired position.
6. Insert carriage bolt back into the column and tighten.
7. Tighten base bracket set screws and socket cap bolt.
PAGE 3 OF 36
SETUP CONTINUED
Display
Indicator
Back
Display
Knob
Display
Cable
AC
Adapter
Socket
Support
Bracket
CONNECTING POWER
The scale can operate continuously by connecting the
AC adapter to an outlet or operate eight hours on a fully
charged battery.
WARNING! Only use the original AC adapter
and battery that came with the scale. Using
an alternative AC adapter or battery could
damage the scale.
AC ADAPTER
Plug the AC adapter into the AC adapter socket on the
back of the indicator. Plug the AC adapter plug into a
standard 110 volt outlet.
WARNING! When AC adapter is not in use, AC
adapter socket must be capped. Leaving the
socket uncapped during water exposure could
result in damage.
NOTE: Verify the local voltage and receptacle
type are correct for the scale.
BATTERY
The scale is equipped with a rechargeable battery.
When the battery voltage is low, a battery symbol will
appear in the lower left-hand corner of the display.
After 15 minutes, the backlight will start to flicker and the
Bat lo
display will show
turn off 30 minutes after the symbol appears.
CHARGING THE BATTERY
When the battery indicator (
lower left-hand corner of the display, the battery needs
to be recharged.
Plug the AC adapter into a power source to charge the
battery. Scale does not need to be turned on. It will take
12 hours to fully charge the battery.
The charging indicator is located on the left side of the
display, above the word CHARGE. The indicator light
color will change to indicate the battery status:
• RED – Battery needs to be recharged.
• ORANGE – Battery is being charged.
• GREEN – Battery is fully charged.
BATTERY MAINTENANCE
Recharge battery every three months when not in use.
If the scale is not used for an extended period of time,
remove the battery from the battery compartment to
avoid leakage. Store the battery in a sealed bag or box
in a dry, temperate environment.
. The scale will automatically
) appears in the
0621 IH-5836
Publicité
Table des Matières
