Correction Of Malfunctions - WAGNER W 650 Mode D'emploi

W 650

Correction of Malfunctions

Problem
No coating material emerges
from the nozzle
Coating material drips from the
nozzle
Atomisation too coarse
Spray jet pulsates
Coating material causes
"paint tears"
Too much fog of coating
material (Overspray)
Cause
Nozzle clogged
Feed tube clogged
Material volume setting turned too far to
the right (-)
Feed tube loose
No pressure build-up in container
Nozzle loose
Nozzle worn
Nozzle seal worn
Coating material build-up on air cap and
nozzle
Viscosity of coating material too high
Material volume too large
Material volume adjusting-screw turned too
far to the left (+)
Nozzle contaminated
Air filter heavily soiled
Too little pressure build-up in container
Coating material in container running out
Air filter heavily soiled
Too much coating material applied
Distance to the object too large
Too much coating material applied
Remedy
Clean
Clean
Turn to the left (+)
Insert
Tighten container
Tighten
Change
Change
Clean
Thin
Turn mat. vol. adjusting screw
to the right (-)
Clean
Change
Tighten container
Refill
Change
Turn material volume adjusting
screw to the right (-)
Reduce distance
Turn material volume adjusting
screw to the right (-)
GB
15