Synchronising With A Can-Bus Connection - Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service

Synchronising with a CAN-bus connection

11 Synchronising with a CAN-bus
connection
Step 1 (synchronisation)
Press and hold the SW1 button on the rear of the electronic module.
Switch on the ignition.
You will hear two high-pitched signals.
Let go of the SW1 button.
Manual transmission: Apply the brake and clutch pedal and keep both
pressed down.
Automatic transmission: Apply the brake pedal and hold it down. Put
the gear into neutral.
Press the SET button on the control element.
The LED on the electronic module starts flashing.
The electronics start to synchronise with the vehicle automatically.
When the synchronisation is complete, you will hear three high-pitched
signals.
The LED on the electronic module lights up permanently.
Manual transmission: Remove your foot from the brake and the clutch
pedal.
Automatic transmission: Remove your foot from the brake pedal and
put the gear into neutral.
NOTE
I
If you do not hear three high-pitched signals, check the connec-
tions to CAN high (blue cable) and CAN low (blue/white cable) and
check whether MagicSpeed MS880 can be connected to the CAN
bus in your vehicle according to the vehicle list.
After successful synchronisation, the electronics automatically continue
with step 2 (pedal test).
88
MagicSpeed MS880
EN