Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service page 81

MagicSpeed MS880
Vehicles with automatic transmission
NOTICE!
A
Never use an engine speed signal. Otherwise the system will not
switch off when the transmission declutches. The engine could
overrun and be damaged!
No additional overspeed protection is required for vehicles with automatic
transmission.
Connect the blue cable to transmit the speed signal.
Vehicles with manual transmission
Connect the blue cable to the travel speed signal.
Connect the yellow cable as overspeed protection using the engine
speed signal or the clutch switch.
Alternatively, you can:
Connect the blue cable to the engine speed signal, or
Connect the yellow cable to the negative terminal end of the ignition coil
(terminal 1).
With this solution, no additional overspeed protection is required because the
engine speed is monitored by the speed regulator. If you use the engine
speed signal, the activation speed of the speed regulator depends on the
gear the vehicle is currently in.
EN
Connecting the electrical power to MagicSpeed
81