Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service page 76

Connecting the electrical power to MagicSpeed
Orange
NOTICE!
A
Make sure the ignition is switched off. Otherwise a fuse may blow.
Connect the orange cable to a connected positive terminal (terminal 15).
Use a voltmeter to check whether the selected positive terminal carries
the full operating voltage of 12 V and that the orange cable carries no
voltage when the ignition is off.
This test is usually done at the fuse box.
NOTICE!
A
Do not connect the orange cable to the voltage supply for the
vehicle accessories (ACC).
Green
Insulate the green cable.
This cable is not needed. The required earth signal is taken from the ac-
celerator cable set.
Green/white and violet
NOTE
I
With a CAN bus connection, these cables are only connected when
there is no clutch signal on the CAN bus in your vehicle. See also
the information in the vehicle-specific product overview at
www.dometic-waeco.com/MS880
Alternatively, you can connect the purple cable with:
a clutch switch
the control lamp for the activated parking brake
(automatic transmission only): the control lamp for park or neutral
You can connect the clutch switch supplied or the vehicle's original clutch
switch (if available) to the green/white and purple cable.
Using the clutch switch supplied
Install the clutch switch as described in chapter "Installing the clutch
switch" on page 74.
76
MagicSpeed MS880
EN