Resetting The Software; Maintaining And Cleaning Magicspeed - Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service

Maintaining and cleaning MagicSpeed

Exceeding the current top speed by kick down
If your system has been configured accordingly, you can exceed the current
top speed by kick down:
Press the accelerator pedal down quickly.
The vehicle accelerates and exceeds the current top speed. The system
limits the vehicle speed to the absolute maximum speed which was set in
the system (see chapter "Setting the absolute maximum speed" on
page 100).
When the current top speed is exceeded, the speed limiter switches off.
Switch it on again as needed and reset the current top speed.
Press the RES button to activate the speed to the speed limiter again.
16.3

Resetting the software

Press and hold the SW1 button on the rear of the electronic module.
Switch on the ignition.
You will hear two high-pitched signals.
Let go of the SW1 button.
Press the SET button on the control element.
The LED on the electronic module starts flashing.
The electronics start to synchronise with the vehicle automatically and re-
set the software to its status when delivered.
After the software is successfully reset, you will hear three signals.
Switch the ignition off.
17 Maintaining and cleaning MagicSpeed
NOTICE!
A
Do not use sharp or hard objects to clean the device as these may
damage the device.
Clean the components with a damp cloth from time to time.
108
MagicSpeed MS880
EN