Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service page 82

Masquer les pouces Voir aussi pour Waeco MagicSpeed MS880:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 114
Connecting the electrical power to MagicSpeed
Recording travel speed signals
NOTICE!
A
On vehicles with manual transmission, an engine overspeed
protection must be installed.
You can record the travel speed signal at the following positions:
Position
Speed signal transmitted via the engine controller
Electronic speed sensor
(on the rear of the instrument assembly or as part
set of the instrument assembly)
Travel speed sensor
(this is installed in the transmission and generally
has three cables)
Car radio
(near the radio, if the vehicle has an ISO connec-
tion. The travel speed signal is in chamber 3,
contact pin 1 or 5)
Recording engine speed signals
You can record the engine speed signal at the following positions:
Position
Engine speed signal transmitted via the engine
controller
Electronic speed sensor
(on the rear of the instrument assembly or as part
set of the instrument assembly)
Negative terminal end of the ignition coil
(terminal 1)
(The yellow cable must be used for this type of
connection)
82
MagicSpeed MS880
Voltage
Frequency
V
Hz
1,5 – 24
6 – 8500
1,5 – 24
6 – 8500
1,5 – 24
6 – 8500
1,5 – 24
6 – 8500
Voltage
Frequency
V
Hz
1,5 – 24
6 – 8500
1,5 – 24
6 – 488
6 – 250
6 – 488
EN

Publicité

Table des Matières
loading

Table des Matières