Manual Rinsing Cycle - Philips 2000 Série Mode D'emploi

Manual rinsing cycle

1 Place a bowl under the hot water/steam wand or classic milk
frother and the coffee spout. Make sure the control dial points to
the coffee bean icon.
2 Press the on/off button.
3 When the warning light flashes quickly, turn the control dial to the
hot water icon and wait a few seconds.
The warning light goes out and some water comes out of the hot
water/steam wand or classic milk frother.
4 After a few seconds, when hot water stops coming out of the hot
water/steam wand and the warning light flashes slowly, turn the
control dial back to the coffee bean icon.
The machine is heating up and the on/off button flashes slowly.
When the machine has heated up, it performs an automatic rinsing
cycle to clean the internal circuit with fresh water. Water flows from
the coffee spout.
When the on/off button lights up continuously, the machine is
ready for the manual rinsing cycle.
Note:You can stop the automatic rinsing cycle by pressing the
espresso button or the regular coffee button.
Note:The automatic rinsing cycle also takes place 30 minutes after
the appliance switches to standby mode or switches off.
During the manual rinsing cycle, the machine brews one cup of coffee
to prepare the inner circuit for use.
English
11