Philips 2000 Série Mode D'emploi page 29

English
30
Problem
The machine grinds
the coffee beans but
no coffee comes out.
The coffee is too
weak.
Water ends up in the
drip tray.
The machine seems to
be leaking.
There is not enough
coffee in my cup.
Solution
If you still cannot place the brew group back. Reinsert the coffee
grounds container and leave the brew group out. Close the
maintenance door, switch on the machine. The machine prepares for
use. Switch off the machine and try to place back the brew group
again.
Clean the coffee exit duct and set the grinder to a coarser setting.
Clean the brew group (see 'Cleaning the brew group').
Fill the water tank with water.
Clean the coffee spout.
Adjust the ceramic coffee grinder to a finer setting (see 'Adjusting the
grinding degree').
Brew a few cups of coffee to let the machine adjust itself to the new
grinding settings.
Use a different type of coffee beans.
This is normal. To guarantee the perfect cup of coffee, the machine
uses water to rinse the internal circuit and brew group. Some of the
water flows through the internal system directly into the drip tray.
Empty the drip tray regularly.
The drip tray is full and overflowed during brewing or the descaling
procedure.
Check if the water tank is leaking.
The brew group or the drains behind or under the brew group may be
blocked. Rinse the brew group with lukewarm water and clean the
upper filter carefully. Also clean the inside of the machine with a soft,
damp cloth.
Air may be present in the internal circuit. Rinse the internal circuit of
the machine by turning the control dial to the hot water icon and
letting
some hot water flow out of the machine.
Clean the brew group (see 'Cleaning the brew group').