Positioning The Seat; Adjusting The Motion-Control Levers; Adjusting The Height; Removing The Discharge Cover For Side-Discharging - Toro TimeCutter ZS 4200S Manuel De L'utilisateur

Positioning the Seat

The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable
Adjusting the
Motion-Control Levers

Adjusting the Height

You can adjust the motion-control levers higher or
lower for maximum comfort
Figure 10
(Figure 9).
Figure 9
(Figure 10).
Adjusting the Tilt
You can adjust the motion-control levers forward or
rearward for your comfort.
1. Loosen the upper bolt holding the control lever
to the control-arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever forward or rearward.
g027249
3. Tighten both bolts to secure the control lever in
the new position.
4. Repeat the adjustment for the other control lever.
Removing the Discharge
Cover for Side-Discharging
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Release the flexible latch from the latch retainer
on the discharge cover and pivot the discharge
cover to the right
g027252
14
Figure 11
ARK
(Figure 12).
g333846