Table des Matières
Publicité
Janome 2250 Instruction Manual
B
C D E F G H
A
2
www.toews.com
J K L
I
A
Pattern Selector Dial
Raise the needle above the fabric and select the desired
pattern at the setting mark by turning the pattern selector
dial.
Stitch Length Dial
•
Place the desired number at the setting mark by
turning the stitch length dial.
•
The higher the number, the longer the stitch length.
"
" is the correct setting for buttonhole stitching.
•
Adjust the dial in the 0.3 to 4 range when you sew the
zigzag stitch.
Selecting Stretch Stitch Patterns
When sewing stretch patterns set the stitch length dial at
"S.S.".
If forward and reverse feeds become unbalanced due to
the type of fabric, adjust the balance as follows:
When patterns are compressed, turn the dial toward "+".
When patterns are drawn out, turn the dial toward "–".
Stitch width dial
•
Place the desired width at the setting mark by
turning the stitch width dial.
The higher the number, the wider the stitch width.
•
When the stitch width is narrower, the right side of
the pattern is cut off.
(Example)
Number [3]
Notice: Raise the needle above the fabric, when you turn
the stitch width dial.
30
Number [5]
QS2250 Owners Manual/ User Guide
Publicité
Table des Matières
