Hayward Salt & Swim Manuel D'utilisation page 8

Connect and Fasten Cell Cap
Slip the Cell Cap through the Retaining Nut as shown below. Plug the Cell Cap into the Cell and
secure with the Retaining Nut. Run the pump for 5 minutes and check for leaks.
Bonding
Pool bonding or "equipotential bonding" ensures that all pool components around the pool are at the
same electrical potential. If bonding is required at your location (see Local and NEC codes), a bonding
lug is provided at the bottom of the Salt & Swim enclosure. Run an eight gauge (8 AWG) solid copper
wire from the bonding lug to your pool's existing bonding loop.
to Pool Bonding loop
6
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS