Electrical Connection - Balluff BTL7-A -M Série Mode D'emploi

BTL7-A/C/E/G_ _ _-M_ _ _ _-A/B/Y/Z(8)-S32/S115/S135/KA_ _
Micropulse Transducer - Rod Style
4
Installation and connection (continued)
Supporting rod made of non-magnetizable material
Fig. 4-8: Example 2, transducer installed with supporting rod
4.4.1 Connector type S32
Pin -A_10 -G_10
1 Not used
1)
2
10 to -10 V
3 10 to 0 V
4
-10 to 10 V
5 0 to 10 V
8
BTL7-_1_ _-...
6 GND
7 20 to 28 V
Unassigned leads can be connected to the GND on the controller side but not to the shield.
1)
Reference potential for supply voltage and EMC-GND.
2)
Tab. 4-2: Connection assignment BTL7...-S32
4.4.2 Connector type S115
Pin -A_10 -G_10
1
2
10 to -10 V
3 10 to 0 V
4
-10 to 10 V
5 0 to 10 V
8
BTL7-_1_ _-...
6 GND
7 20 to 28 V
Unassigned leads can be connected to the GND on the controller side but not to the shield.
1)
Reference potential for supply voltage and EMC-GND.
2)
Tab. 4-3: Connection assignment BTL7...-S115
10 english
Magnet
(e.g. BTL-P-1028-15R)
-C_00 -C_70
0 to 20 mA 20 to 0 mA 4 to 20 mA
0 V
Not used
La (programming input)
Not used
Lb (programming input)
BTL7-_5_ _-...
2)
-C_00 -C_70
0 V (pin 3)
0 V (pin 5)
Not used
La (programming input)
0 to 20 mA 20 to 0 mA 4 to 20 mA
Lb (programming input)
BTL7-_5_ _-...
2)
4.4

Electrical connection

Depending on the model, the electrical connection is made
using a cable (BTL7...-KA) or a connector (BTL7...-S32,
BTL7...-S115, BTL7...-S135).
The connection or pin assignments for the respective
version can be found in Tables 4-2 to 4-5.
Note the information on shielding and cable
routing on page 11.
-E_00 -E_70
20 to 4 mA
1)
Fig. 4-9:
1)
GND
2)
10 to 30 V
-E_00 -E_70
1)
Fig. 4-10:
20 to 4 mA
GND
2)
10 to 30 V
Pin assignment of S32 (view of
connector pins of transducer),
8-pin M16 circular plug
Pin assignment of S115 (view of
connector pins of transducer),
8-pin M12 circular plug