Basic Settings; Activating The Settings Menu - SilverCrest SIUR 10 A1 Mode D'emploi

NOTE
► The device is not fi tted with a power switch. To disconnect the device from
the power supply, the power plug must be pulled out of the power socket.

Basic settings

When the device has been connected to the power supply, it is in the clock/stand-
by operating mode. The welcome message
appears in the display
tings for the clock and date using the RDS signal. After a successful update, the
time, the abbreviation for the weekday and the date will be shown in the display
Should the automatic update fail, make the adjustments manually.
NOTE
► The device is controlled using touch-sensitive control points and areas. In
order to prevent inadvertent device operation, you can lock the controls
with the key lock function (see also chapter Lock controls).

Activating the settings menu

To activate the settings menu, press the Set|OK control point
standby operating mode or press the Set OK key
The hours shown in the time display
the Set|OK control point
switches to the next menu item. The menu item sequence is:
● Set the time
● Set the date
● Set reminder functions 1 – 6
● Set the update function
● Set the automatic dimmer function
● Set the time of day format
● Set the "LOC" operating location
● To set the world time, select from "CITY".
● Set I-Sync
● Set the snooze time
SIUR 10 A1
PLEASE WAIT FOR SETTING THANKS
. In the meantime, the device attempts to update its set-
start to blink. Each additional touch of
or press of the Set OK key
when in clock/
on the remote control.
on the remote control
.
GB
131