Electric Connection - GOK BC-1 Notice De Montage Et De Service

Assembly insert
After having DETERMINED THE ADJUSTING DIMENSION X, the insert must be locked.
The insert is used to fasten the probe within the tank.
The insert has locking screws which secure the probe tube against moving. Manually screw-in
and fasten the insert using a gasket or sealing materials. The installation is done from above.
When adjusting the required response height of the probe (adjusting dimension X), the probe
must be secured against unintentional adjustment by using the locking screw(s).
Connecting threads present on the tank larger than G1 can be brought to the
connecting thread G1 of the insert by using commercially available reducers. Due to
the partial increase of the fitting edge, the following is applicable: X = a + k + k

ELECTRIC CONNECTION

Safety precautions for electrical components
The functions and operating safety of the device are guaranteed only under the climatic
conditions that are specified in TECHNICAL DATA. If the device is transported from a cold to
a warm environment, condensation may cause the device to malfunction or may even destroy
the device. Because of this, you must ensure that the device has acclimatised to the ambient
temperature before using it.
If you have any doubts that the device can be operated safely, do not operate it. Your safety
may be adversely affected by the device, if for example:
• it is obviously damaged
• it no longer works as specified
• it has been stored in unsuitable conditions for some time,
if in doubt, send the device to the manufacturer for repair or maintenance
Do not use this device for safety applications or emergency stop mechanisms
or misuse it!
Injuries and damage to health and property through misuse.
You must observe the information contained in these instructions, especially
regarding installation, start-up and maintenance.
8 / 16
Insert G 3/4
• loosen the locking screw
• set the determined adjusting dimension X.
• tighten the locking screw
be moved.
Insert G 1
• loosen the upper locking screw
a
• set the determined adjusting dimension X.
• tighten the locking screw
cannot be moved.
• screw-in the tank insert into the tank.
• tighten the upper locking screw
Overfill prevention divice type BC-1
on the insert.
so that the probe tube
.
in such a way that the probe tube
.
cannot
Reducer.