On / Off Switch; Motor Protection; Dust/Chip Exhaustion; Riving Knife Setting - ATIKA PTK 250 S Notice Originale

Main fuse: 16 A
Use the connection or extension cable according to IEC 60245
(H 07 RN-F) with a core cross-profile section of at least
1.5 mm2 for cable lengths up to 25m
2.5 mm2 for cable lengths over 25m
Power system impedance
In case of disadvantageous power system conditions short-term
voltage reductions can occur during the starting process of the
device which can influence other devices (e.g. jittering of a
lamp).
Such influences are not expected at a system impedance of
Z 0.382 Ω. For more information contact your local power
max
supply company.

On / Off Switch

Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
Switch on
Press the green button ( I )
on the switch.
If there is a power cut, the
machine switches
automatically. To switch on
again, press the green ( I )
button.
Switch off
Press the red button ( 0 ) on the switch.

Motor protection

The motor is equipped with a safety switch and
switches off independently when overloaded.
It can be switched back on following cooling phase (5 -
10 min.) .
First press
1. the red button (0)
2. the small black button (37)
3. the green button ( I ) to start

Dust/chip exhaustion

The wood dust generated during operation impedes the
necessary view and is harmful to health to some degree.
When sawing wood a chip exhaustion system (e.g. portable
small vacuum) has to be connected to the exhaust neck (32).
off
Chip exhaustion
Connect a chip exhauster or a small vacuum to the chip
exhaust neck (32) (Ø 39 mm) using a suited adapter.
Air velocity at the exhaust neck of the saw ≥ 20 m/sec
Use a special exhaust device when exhausting dusts that are
especially harmful to health, carcinogen or dry.
A d j u s
A d j u s
Pull the mains plug before performing
settings.

Riving knife setting

The riving knife is an important safety device as it prevents the
workpiece from recoiling
Always use the supplied riving knife.
To guarantee the function of the riving knife, its
distance from the toothed wheel its distance from the teeth
of the saw blade above the table must not be more than 2-5
mm.
Screw off the 8 screws from the table insert and
remove the table insert.
The saw blade must be in the highest position.
Slightly loosen the 2 hexagon screws and correctly adjust
the riving knife. The riving knife must be in line with the saw
blade.
Comply with the stated dimensions.
Tighten the two hexagon screws using the ring wrench (25).

Telescoping table extension

, Loosen the two wing screws under the saw table
on the left and right side and pull out the table extension (6)
to the desired extent.
Then, tighten the wing screws again.

Sliding carriage

Turn the locking lever (21) counterclockwisely to be
able to move the sliding carriage.

Set the cutting height

The cutting height can be continuously adjusted from 0
to approx. 74 mm using the handle (18).
Before setting the cut height, tighten the set screw for the
saw blade (20).
Set the cutting height 5 mm higher than the material
thickness.
t i n g t h e s a w
t i n g t h e s a w
19