Multi-Use Slicer - SEVERIN AS 3914 Mode D'emploi

GB

Multi-use slicer

Dear Customer,
Before using the appliance, please read the
following instructions carefully and keep this
manual for future reference. The appliance
must only be used by persons familiar with
these instructions.
Connection to the mains supply
The appliance should only be connected
an earthed socket installed in accordance
with the regulations.
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the appliance. This product
complies with all binding CE labelling
directives.
Familiarisation
1. On/Off switch
2. Thickness selection knob
3. Cutting blade
4. Central locking screw
5. Sliding tray
6. Power cord
7. Rating label (on underside of the unit)
8. End-piece holder with fi nger guard
9. Stop plate
Important safety instructions
∙ The appliance may only be used
by persons with reduced physical,
sensory or mental capabilities, or
lacking experience and knowledge,
if they have been given supervision
or instruction concerning the use of
8
the appliance and fully understand
all dangers and safety precautions
involved.
∙ Children must not be permitted to
operate the appliance. The appliance
and its power cord must be kept well
away from children.
∙ Children must not be permitted to
to
play with the appliance.
∙ Caution: Keep any packaging materials
well away from children – these materials
are a potential source of danger, e.g. of
suffocation.
∙ Do not leave the appliance unattended
while connected. Always remove the plug
from the wall socket, even if you leave the
room only for a short while.
∙ Before the appliance is used, the main
body as well as any fi tted attachments
should be checked thoroughly for any
defects. If the appliance, for instance,
has been dropped onto a hard surface, it
must no longer be used: even invisible
damage may have adverse effects on its
operational safety.
∙ The power cord should be regularly
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
∙ Do not allow the appliance to touch hot
surfaces (e.g. oven-plates) or to come
into contact with any open heat sources.
∙ For safety reasons, always bring the stop
plate to its rest (zero) position after use,
so that it is fl ush with the blade.
∙ Caution: the appliance should only be
operated with the sliding tray and end-