Recycling & Disposal - Cooke & Lewis CLFLEX4Z60 Mode D'emploi

Safety
FC The connection between the display board and the
main board has failed.
E1/E2 Abnormal supply voltage.
E3/E4 Temperature sensor of the ceramic glass plate is high.
E5 Temperature sensor of the IGBT is high.
Specific failure & solution
Problem
The LED does not come on when unit
is plugged in.
Some buttons can't work, or the LED
display is not normal.
The Cooking Mode Indicator comes
on, but heating does not start.
Heating stops suddenly during
operation and the display flashes "u".
Multiple cooking zones display "u".
Fan motor sounds abnormal.
Recycling & disposal
Waste electrical products (WEEE) should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local governmental authority, domestic waste disposal
services or the retailer where the product was bought for recycling advice. The wheelie bin symbol on the product
or its packaging indicates that this product cannot be treated as normal household waste. This product must be handed
over to an electric and electronic equipment collection point for recycling.
On ensuring that this product is disposed of correctly, you will help to avoid possible negative consequences for the
environment and public health, which could occur if this product is not handled correctly.
208848_s1_s4-5059340127521-C&L-A4-IM-INT-Safety-V01.indd 7 208848_s1_s4-5059340127521-C&L-A4-IM-INT-Safety-V01.indd 7
Possible causes
No power supplied.
The accessory board and display
board connection has failed.
The accessory power board is
damaged.
The display board is damaged.
The display board is damaged.
High temperature of the hob.
The fan has failed.
The power board is damaged.
The pan type is not suitable.
The pan diameter is too small.
The hob has overheated.
The pan detection circuit is damaged.
The power board and display board
connection has failed.
The display board has failed.
The main board has failed.
The fan motor is damaged.
Contact the Customer Service helpline shown in
this manual.
Please inspect whether power supply is normal.
Power on after the power supply is normal.
Please restart after the induction hob cools down.
Please restart after the induction hob cools down.
Check the mains power supply cable
and RCD at the consumer unit.
Contact the Customer Service
helpline shown in this manual.
Contact the Customer Service
helpline shown in this manual.
Check that the air vents are not
blocked.
Contact the Customer Service
helpline shown in this manual.
Use the correct pan. See the section
'Cookware' in the instructions.
The hob has overheated. Let the
hob cool down and push 'On / Off' to
restart.
Contact the Customer Service
helpline shown in this manual.
Contact the Customer Service
helpline shown in this manual.
Contact the Customer Service
helpline shown in this manual.
7
Solution
22/9/2020 7:08 PM 22/9/2020 7:08 PM