Service; Declaration Of Conformity - Walter WWS-IGS1000 Notice D'utilisation D'origine

• Please be ready with the sales receipt and the product number as proof or
purchase for all queries.
• You can refer the product number from the type label, an engraving, on the
cover sheet of your operating instructions (below left) or as sticker on the back
or lower side.
• If functional or other defects occur, first call or email the following service
department.
• You can then send a product recorded as defective postage free along with
the sales receipt and information about where the defect lies and when it has
occurred, to the service centre address provided to you.
This and many other manuals, product videos and software can be downloaded
at www.walteronline.com/service

Service

Walter Werkzeuge Service Center
E-Mail: service@walteronline.com
Tel.: 00800 925 837 88
Supplier:
Please note that the following address is not a service centre address. Please
contact the above-mentioned service centre first.
Walter Werkzeuge Salzburg GmbH
Gewerbeparkstr. 9, 5081 Anif, Austria

Declaration of conformity

The EU declaration of conformity can be found on the penultimate page of this
manual.
www.walteronline.com/service
Service
85