Overload Protection - Walter WWS-IGS1000 Notice D'utilisation D'origine

Overload protection

The power sockets of the generator are equipped with overload protection. If
the load is too high or if the connected electrical equipment malfunctions, the
overload protection switches off the socket.
• The red overload indicator
lights up when the generator is
overloaded.
When the overload protection automatically turns off the socket:
• Switch off the connected electrical equipment.
• Unplug the mains plug from the power socket.
• Compare the values for the continuous and maximum power of the electrical
equipment with those of the generator (see chapter "Technical data").
• Check whether the electrical equipment is defective.
• By switching off and restarting the engine, the socket can be put back into
operation after the overload protection has been triggered (see chapter
"Starting the generator" and "Switching off the generator").
• Switch off the power generator immediately if the overload protection switches
off the sockets again (see chapter "Switching off the power generator").
20
20
Using the power generator
16
.
69